Hardware:




Software:

 mainnewsproductsmanualssoftwarecommunitywhere to buy

::: SmartXX Version 1 Quicksolder-Install :::

Remove the six screws on the bottomside of your box:


Unplug the two cables of the harddisk (yellow arrows)
Remove the three screws of your DVD-Drive (green arrows)


Remove the harddisk carefully
Unplug the two cables of your DVD-Drive (yellow arrows)


Unplug the five cables (yellow arrows)
Remove the screws of the mainboard (green arrows)

Solder your SmartXX to the LPC-Port like seen on the photo
and switch on DIP 6 !


For the LPC rebuild use the included PCB.
The yellow arrows are showing you the solderpoints on the board.


All you have to do is solder the rebuild PCB on the marked points
(the yellow arrows) to your board. Don´t forget to solder the twelve
points of the LPC Port.
You can use the hole next to LFrame soldering pad to plug the wire
THROUGH! your board and solder it to the DO point on your SmartXX.
That´s all, have fun with your SmartXX !

If you don´t want to use the PCB or you don´t have it anymore,
just solder the yellow connections with isolated wires and
the LFrame wire to the D0-Point of your SmartXX.